Picture Name
Picture Name

Can produce all aluminum alloy assembly type, all stainless steel combination type, brick masonry and other structures of semi-automatic and fully automatic control drying kiln

20

2018

-

12

How to maintain the desiccant?

1. The necessary preparations should be made before the drying equipment is started. First of all, check whether the connection between the bearing and the sealing part of each device is loose, the lubricating oil condition of each mechanical part and whether the valve ports of each water, air and slurry pipe are in the required position. Then turn on the power to check the boiling granulation dryer to check whether the voltage and instrument are normal, and finally check the amount and concentration of slurry in the slurry mixing barrel. If there is any problem, it should be eliminated in time. 2. After the normal operation of the drying equipment, the materials should be collected regularly, the operation of each system should be checked regularly, the process parameters should be recorded, and the vibrating filter screen should be cleaned. 3. In case of emergency


1. The necessary preparations should be made before the drying equipment is started. First of all, check whether the connection between the bearing and the sealing part of each device is loose, the lubricating oil condition of each mechanical part and whether the valve ports of each water, air and slurry pipe are in the required position. Then turn on the power to check the boiling granulation dryer to check whether the voltage and instrument are normal, and finally check the amount and concentration of slurry in the slurry mixing barrel. If there is any problem, it should be eliminated in time.
 
2. After the normal operation of the drying equipment, the materials should be collected regularly, the operation of each system should be checked regularly, the process parameters should be recorded, and the vibrating filter screen should be cleaned.
 
In case of emergency, the drying equipment must be shut down immediately.
 
4. Drying equipment for a long time or due to improper operation, some of the drying equipment will appear aggregate and affect the normal operation, at this time need to stop working for cleaning. For the cleaning of aggregate in the drying tower, the cleaning door should be opened, the aggregate at the bottom of the funnel should be swept with a long broom, the discharge valve should be opened, and the boiling granulation dryer tower should be rinsed with tap water. To remove the dust collected in the boiling granulation dryer of the cyclone separator, it is also necessary to open the cyclone separator, clean the aggregate with a broom, and rinse with water if necessary. For the cleaning of the dust collector of the bag-type deboiling granulation dryer, the control switch should be turned on, continuous knocking, then the cleaning door should be opened, the cloth bag is knocked to remove dust from the boiling granulation drying machine, and finally the filter bag boiling granulation dryer should be replaced. For the cleaning of the slurry pipeline system, the drain valve of the two-way filter should be opened, the filter screen and pipeline of the boiling granulating dryer should be cleaned, and then the material pump should be opened to substitute water for material, and the pump pipe, pressure stabilizing bag and pipeline should be cleaned.